BURN ORTHOPAEDICS
  • Home
  • Procedures
    • Total Hip Replacement - Primary
    • Total Hip Replacement - Revision
    • The Upper Tibial Wedge Opening Osteotomy
    • Hemi-Knee Replacement
  • Instruments
    • The STAR DRILL
    • THE BURN HIP CALIBRATION GAUGE
  • Contact
THE BURN

HIP CALIBRATION GAUGE

THE SIMPLEST AND MOST POWERFUL DEVICE FOR PRECISION IN TOTAL HIP ARTHROPLASTY

"The Hip Gauge is to Total Hip Arthroplasty, as GPS is to safe aviation."

The Hip Calibration Gauge was first published on in the Proceedings of the Journal of Bone and Joint Surgery (Br) in 1988 70B Number 3 p508. It is reusable and manufactured by Enztec Ltd. A full surgical technique is available on Enztec's website and should be read (most surgeons do not take full advantage of the device, many have tried to copy but miss the important knowledge).

TO SET ACETABULAR INCLINATION AND ANTEVERSION, LEG LENGTH CHANGE, OFFSET CHANGE
The error is +/- 3mm. Offset change also is critical to the hip surgeon and avoids falling into traps. Acetabular mal-placement (version and inclination) is the most common cause of squeaking in CoC hips and excessive wear in hard on soft articulations. Leg length error is "fodder" for our lawyers!

RADIOLOGY REQUIRED BEFORE USE:
1. AP hips standing and calibrated
2. A standing DIRECT LATERAL with the affected hip away from the film, hips and knees flexed until the spine is "comfortable" in cases of fixed flexion deformity (a sitting direct lateral can also be done at the surgeons direction).

For further help or ppt of it's use contact P James Burn.
Powered by Create your own unique website with customizable templates.
  • Home
  • Procedures
    • Total Hip Replacement - Primary
    • Total Hip Replacement - Revision
    • The Upper Tibial Wedge Opening Osteotomy
    • Hemi-Knee Replacement
  • Instruments
    • The STAR DRILL
    • THE BURN HIP CALIBRATION GAUGE
  • Contact